Sony L50w strong flash official FTF firmware tutorials and official firmware package

Date: 2015-08-20    Views: 3927    press people: clown youthone hundred million Chilean mushrooms official micro letter

Sony L50w how strong brush official FTF firmware it? The following Xiaobian finishing the Sony L50w strong brush official FTF firmware tutorials and official firmware package for them to learn, Check it out! ...

  Sony L50w how strong brush official FTF firmware it? The following Xiaobian finishing the Sony L50w strong brush official FTF firmware tutorials and official firmware package for them to learn, Check it out! 
A: Sony L50w Brush the preparatory work before:

1: Make sure your phone can be connected to the computer usb data cable, this is a must

2: Install the Sony drive L50w

3: Download the official firmware package

4: Download Brush tool

Two: Sony L50w began to brush the official firmware package:

1: The above first downloaded FlashTool Brush tool decompression on the computer, as shown below:

 

2: Then put the top downloaded tft strong brush into your unzip the firmware file member FlashTool good firmwares file formats folder

3: Next is to install Flashtool drive into the drivers folder run Flashtool-drivers.exe, the next step has been the next step, as shown encountered checked, you can tick all, no serious problem!

4: After installing the drive, run FlashTool.exe (64-bit systems running FlashTool64.exe), select the writing brush, brush mode select, confirm

 

5: After selecting the firmware clears the data to the right and press the tick to confirm

 

6: After occur at the interface, please wait for a little while (1 to 5 minutes, do not worry).

 

7: will appear after about 1-5 minutes Interface

8: At this time, the phone off, and wait at least 10 seconds after the black screen above (in fact according to my feeling of five seconds is enough, officials say 30 seconds, not too short, everyone wants to find in a hurry). Hold down the "Volume -" buttons at the same time with a data cable to connect your phone and computer.

Wait animation interface disappears above that, while the upper corner of the phone lights up green, release the "volume -." First brush, and probably because the computer to install the driver slightly longer, if for this reason fails, you can wait for the end of the steps to re-install the driver pulled out from the above data line to start.

9: FlashTools main interface will display a progress bar and log Brush

10: When the progress bar has completed and the log the last five as shown below

11: Description Brush successful, you can unplug the power cord, and turn to.

Sony L50w strong flash official FTF firmware tutorials and official firmware package 10:09:00 PM